Toyota Camry (XV70): Installation

Toyota Camry Repair Manual XV70 (2018-2024) / Vehicle Interior / Meter / Gauge / Display / Combination Meter / Installation

INSTALLATION

PROCEDURE

1. INSTALL COMBINATION METER ASSEMBLY

(a) Connect each connector.

(b) Engage the clamp.

Install in this Direction

(d) Install the combination meter assembly with the 3 screws.

2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

(a) Connect the connector.

(b) Engage the 2 guides and 4 clips as shown in the illustration.

Install in this Direction

(d) Engage the 4 clips and 2 claws to install the instrument cluster finish panel assembly.

Install in this Direction

3. INSTALL NO. 2 METER HOOD CLUSTER

Click here

4. INSTALL NO. 1 METER HOOD CLUSTER

Click here

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

for A25A-FKS:

Click here

for 2GR-FKS:

Click here

SEE MORE:

Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pump control ECU removal/installation are shown below. Necessary Procedures After Parts Removed/I

Distance Control Switch Circuit

DESCRIPTION The vehicle-to-vehicle distance control switch is used to set the distance for vehicle-to-vehicle distance control mode. The vehicle-to-vehicle distance control switch is installed in the steering pad switch assembly. The vehicle-to-vehicle distance set value can be changed by operating

Toyota Camry (XV70): Installation

READ NEXT:

SEE MORE:

Removal

Distance Control Switch Circuit