Toyota Camry (XV70): Left Front Wheel Speed Sensor Signal Stuck High (C050024)
Toyota Camry Repair Manual XV70 (2018-2024) / Brake / Brake Control / Dynamic Control Systems / Vehicle Stability Control System (w/ Electric Parking Brake System) / Left Front Wheel Speed Sensor Signal Stuck High (C050024)
DESCRIPTION
Refer to DTC C050012
Click here
.gif)
|
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
|---|---|---|---|
|
C050024 | Left Front Wheel Speed Sensor Signal Stuck High |
The speed sensor signal is not within the specified range for 5 seconds or more. |
Front speed sensor LH |
CAUTION / NOTICE / HINT
NOTICE:
After replacing or removing and installing a speed sensor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.
Click here
PROCEDURE
| 1. |
REPLACE FRONT SPEED SENSOR LH |
(a) Replace the front speed sensor LH.
Click here
| NEXT | .gif) | END |
READ NEXT:
Left Front Wheel Speed Sensor Internal Electronic Failure (C050049)
DESCRIPTION When the system is starting up and the skid control ECU (brake actuator assembly) detects a speed sensor circuit malfunction via the speed sensor circuit self-diagnosis function, this DTC
Right Front Wheel Speed Sensor Circuit Short to Battery (C050612)
DESCRIPTION Each speed sensor detects wheel speed and sends signals to the skid control ECU (brake actuator assembly). These signals are used by the ABS control.
The speed sensor detects the magneti
Right Front Wheel Speed Sensor Circuit Short to Ground or Open (C050614)
DESCRIPTION Refer to DTC C050612 Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
C050614 Right Front Wheel Speed Sensor Circuit Short to Ground or O
SEE MORE:
Sensor (Motor) Failure (B2341,B2344)
DESCRIPTION When the sliding roof ECU (sliding roof drive gear sub-assembly) detects a motor malfunction and the sliding roof operation is stopped, DTC B2341 is stored.
When the sliding roof ECU (sliding roof drive gear sub-assembly) detects a gear position malfunction and the sliding roof operat
Removal
REMOVAL PROCEDURE 1. REMOVE LOWER STEERING COLUMN COVER SUB-ASSEMBLY
Click here 2. REMOVE UPPER STEERING COLUMN COVER
Click here 3. REMOVE TURN SIGNAL SWITCH
(a) Remove the 2 screws.
(b) Using a screwdriver with its tip wrapped with protective tape, disengage the
© 2023-2026 Copyright www.tocamry.com
