Toyota Camry (XV70): Left Rear Wheel Speed Sensor Signal Stuck High (C050C24)
Toyota Camry Repair Manual XV70 (2018-2024) / Brake / Brake Control / Dynamic Control Systems / Vehicle Stability Control System (w/o Electric Parking Brake System) / Left Rear Wheel Speed Sensor Signal Stuck High (C050C24)
DESCRIPTION
Refer to DTC C050C12
Click here
.gif)
|
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
|---|---|---|---|
|
C050C24 | Left Rear Wheel Speed Sensor Signal Stuck High |
The speed sensor signal is not within the specified range for 5 seconds or more. |
Rear speed sensor LH (rear axle hub and bearing assembly LH) |
CAUTION / NOTICE / HINT
NOTICE:
After replacing or removing and installing a speed sensor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.
Click here
PROCEDURE
| 1. |
REPLACE REAR AXLE HUB AND BEARING ASSEMBLY LH |
(a) Replace the rear axle hub and bearing assembly LH.
Click here
| NEXT | .gif) | END |
READ NEXT:
Left Rear Wheel Speed Sensor Internal Electronic Failure (C050C49)
DESCRIPTION When the system is starting up and the skid control ECU (brake actuator assembly) detects a speed sensor circuit malfunction via the speed sensor circuit self-diagnosis function, this DTC
Right Rear Wheel Speed Sensor Circuit Short to Battery (C051212)
DESCRIPTION Each speed sensor detects wheel speed and sends signals to the skid control ECU (brake actuator assembly). These signals are used by the ABS control.
The speed sensor detects the magneti
Right Rear Wheel Speed Sensor Circuit Short to Ground or Open (C051214)
DESCRIPTION Refer to DTC C051212 Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
C051214 Right Rear Wheel Speed Sensor Circuit Short to Ground or Op
SEE MORE:
Indicator Circuit
DESCRIPTION The LTA indicator output request signal is sent from the forward recognition camera to the combination meter assembly via CAN communication. CAUTION / NOTICE / HINT
NOTICE: When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly
Data List / Active Test
DATA LIST / ACTIVE TEST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
When diagnosing symptoms such as hesitation, rough idle, or other small sympto
© 2023-2026 Copyright www.tocamry.com
