Toyota Camry owners & service manuals

Toyota Camry (XV70): On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. SECURE VEHICLE

(a) Fully apply the parking brake and chock a wheel.

CAUTION:

  • Make sure to apply the parking brake and chock a wheel before performing this procedure.
  • If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

2. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION

(a) Turn the engine switch on (IG).

(b) Depress the brake pedal and check that the engine can be started when the shift lever is in N or P, but cannot be started in any other position.

(c) Check that the back-up lights come on when the shift lever is moved to R, but do not come on with the shift lever in any other position.

If the operation is not as specified, check the park/neutral position switch assembly.

Click here

    READ NEXT:

     Removal

    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during pa

     Inspection

    INSPECTION PROCEDURE 1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY NOTICE: Both the park/neutral position switch assembly and transmission control shaft lever are available in two different shape

     Shift Lever Knob

    ComponentsCOMPONENTS ILLUSTRATION *1 SHIFT LEVER KNOB SUB-ASSEMBLY - - RemovalREMOVAL PROCEDURE 1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (a) Disengage the 2 claws to disc

    SEE MORE:

     Data List / Active Test

    DATA LIST / ACTIVE TEST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. When diagnosing symptoms such as hesitation, rough idle, or other small sympto

     Stop Lamp Relay Actuator Stuck On (C13807E)

    DESCRIPTION When any of the following conditions are met, the skid control ECU (brake actuator assembly) sets the drive output (STPO) ON which operates the stop light control relay (stop light switch assembly) and turns on the stop lights. Illumination Conditions: Pre-collision brake is operati

    © 2023-2026 Copyright www.tocamry.com