Toyota Camry owners & service manuals

Toyota Camry (XV70): Operation Check

OPERATION CHECK

CHECK WINDOW DEFOGGER SYSTEM

(a) Turn the ignition switch to ON.

(b) Check that the rear window defogger wire becomes warm by operating the rear window defogger switch of the air conditioning control assembly.

(c) When the vehicle is stopped, confirm that the window defogger system operation stops after approximately 15 minutes.

NOTICE:

If the battery voltage is low, the window defogger system may not operate due to operation of battery load control, check the Data List item "Battery Control Count (Body ECU)".

Click here

HINT:

  • If both of the following conditions are met approximately 15 minutes after the window defogger system was activated, the window defogger system will continue to operate up to approximately 45 minutes. If the following conditions are not met, the window defogger system stops operating immediately.
    • The outside temperature is -3

      READ NEXT:

       Problem Symptoms Table

      PROBLEM SYMPTOMS TABLE HINT: Inspect the fuses and relays related to this system before inspecting the suspected areas below. Use the table below to help determine the cause of problem

       Terminals Of Ecu

      TERMINALS OF ECU CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY *A w/o Seat Heater System *B w/ Seat Heater System *C Dual Type Automatic Air Conditioning System *

       Diagnosis System

      DIAGNOSIS SYSTEM CHECK DLC3 (a) Check the DLC3. Click here INSPECT BATTERY VOLTAGE (a) Measure the battery voltage. Standard Voltage: 11 to 14 V If the voltage is below 11 V, recharge or r

      SEE MORE:

       Installation

      INSTALLATION PROCEDURE 1. INSTALL REAR STABILIZER BUSHING (a) Install the 2 rear stabilizer bushings to the outside of the stoppers on the rear stabilizer bar. NOTICE: Be sure to install the rear stabilizer bushings so that each cutout faces the front of the vehicle. HINT: The cutout of

       Portable Player cannot be Operated Using In-vehicle Device or Track Information is not Displayed on In-vehicle Device

      PROCEDURE 1. CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL (a) Check if track information is displayed normally on another "Bluetooth" audio compatible vehicle of the same model. OK: Track information is displayed normally. OK PROCEED TO NEXT SUSP

    © 2023-2026 Copyright www.tocamry.com