Toyota Camry (XV70): Operation Check
OPERATION CHECK
CHECK FUNCTION
(a) Check that the key reminder warning buzzer sounds.
(1) With the driver door closed, insert the key into the ignition key cylinder and then make sure that the ignition switch is off or ACC.
(2) Check that the buzzer sounds intermittently if the driver door is opened.
(b) Check that the key reminder warning buzzer stops.
(1) Check that the buzzer stops sounding if any of the following operations is performed while the buzzer is sounding:
- Close the driver door (driver door courtesy light switch is off).
- Turn the ignition switch to ON.
- Pull out the key from the ignition key cylinder.
READ NEXT:
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of
TERMINALS OF ECU CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
(a) Remove the main body ECU (multiplex network body ECU) from the instrument panel jun
DATA LIST / ACTIVE TEST DATA LIST HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. T
SEE MORE:
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during windshield glass sub-assembly removal/installation are shown below. Necessary Procedures After Parts
PROBLEM SYMPTOMS TABLE
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
When replacing the radio and display receive