Toyota Camry (XV70): Panoramic moon roof
Use the overhead switches to operate the panoramic moon roof
and electronic sunshade.
Opening and closing the electronic sunshade
- Opens the electronic sunshade
Slide and hold the
switch
backward. The electronic sunshade
will fully open automatically.*
- Closes the electronic sunshade
Slide and hold the
switch
forward.
The electronic sunshade will
fully close automatically.*

*: Quickly slide and release the
switch in either direction to stop the
electronic sunshade partway.
Tilting the panoramic moon roof up and down
Tilts the panoramic moon roof up
(press)*
When the panoramic moon roof is
tilted up, the electronic sunshade
will open to the half-open position
of the roof.

*: Lightly press the
switch
again to stop the panoramic moon
roof partway.
Tilts the panoramic moon roof down (press and hold)
The panoramic moon roof can be tilted down only when it is in the tilt-up
position.
READ NEXT:
Opens the panoramic moon roof*
Slide and hold the switch
backward. The panoramic moon
roof and electronic sunshade will
open automatically.
The panoramic moon roof can be
opened from the tilt-u
SEE MORE:
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission valve body assembly removal/installation are shown below. Necessary Procedures After Part
INSTALLATION PROCEDURE 1. INSTALL CAMSHAFT TIMING GEAR BOLT
(a) Make sure that the No. 1 cylinder is at TDC/compression. HINT:
Check that the cutout of the camshaft timing gear assembly is at the top and align the timing mark (cutout) of the crankshaft pulley with the timing mark on the timing c