Toyota Camry (XV70): Precaution
PRECAUTION
HANDLING PRECAUTIONS FOR STEERING SYSTEM
(a) Care must be taken when replacing parts. Incorrect replacement may affect the performance of the steering system and result in a driving hazard.
HANDLING PRECAUTIONS FOR SRS AIRBAG SYSTEM
(a) This vehicle is equipped with a Supplemental Restraint System (SRS). Failure to carry out service operations in the correct sequence could cause the SRS to unexpectedly deploy during servicing. This may cause a serious accident. Before servicing (including inspection, replacement, removal, and installation of parts), be sure to read the precautionary notices for Supplemental Restraint System.
Click here .gif)
HANDLING PRECAUTIONS FOR STEERING COLUMN
(a) Do not release the tilt lever when the steering column assembly is not installed on the vehicle.
HANDLING PRECAUTION FOR SPIRAL CABLE
(a) Do not remove/install the spiral cable with sensor sub-assembly with the battery connected and the ignition switch ON.
(b) Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the battery connected and the ignition switch ON.
(c) Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.
(d) Be sure that the spiral cable is in the center position during installation and when removing and installing the steering wheel.
Click here
CAUTION:
If the steering wheel is turned without the spiral cable installed in the center position, the cable may break.
READ NEXT:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in or
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT STEERING WHEEL FREE PLAY (a) Start the engine and make sure that the vehicle is in a state in which the power steering can operate.
(b) Stop the vehicl
Adjustment
ADJUSTMENT PROCEDURE 1. STEERING WHEEL OFF CENTER ADJUSTMENT PROCEDURE
(a) Inspect steering wheel off center. (1) Turn the steering wheel assembly to the center position.
(2) Apply masking t
SEE MORE:
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL PLANETARY GEAR
(a) Apply high-temperature grease to the 3 planetary gears, 3 planetary gear shafts and repair service starter kit.
High-temperature Grease (b) Install the 3 planetary gears to the repair service starter kit.
2. INSTALL STARTER A
XM Tuner Antenna Disconnected (B15FE,B15FF)
DESCRIPTION These DTCs are stored when a malfunction occurs in the roof antenna assembly which is connected to the radio and display receiver assembly.
DTC No. Detection Item
DTC Detection Condition Trouble Area
B15FE XM Tuner Antenna Disconnected
The telephone antenna
