Toyota Camry (XV70): Precaution
PRECAUTION
PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.
|
System Name | See Procedure |
|---|---|
|
Lane Tracing Assist System |
|
|
Pre-collision System | |
|
Parking Assist Monitor System | |
|
Panoramic View Monitor System |
.gif)
IGNITION SWITCH EXPRESSIONS
(a) The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
|
Expression | Ignition Switch (Position) |
Engine Switch (Condition) |
|---|---|---|
|
Ignition Switch off |
LOCK | Off (Lock) |
|
Ignition Switch ACC |
ACC | On (ACC) |
|
Ignition Switch ON |
ON | On (IG) |
|
Engine Start | START |
On (Start) |
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION
*1 FUEL LID LOCK WITH MOTOR ASSEMBLY
*2 FUEL LID OPENER SWITCH
*3 INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
- FUEL OPN RELAY
*
System Diagram
SYSTEM DIAGRAM
System Description
SYSTEM DESCRIPTION FUEL LID OPENER SYSTEM DESCRIPTION
When the fuel lid opener switch is pushed for 0.8 seconds, the main body ECU (multiplex network body ECU) turns on the fuel lid open relay to o
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY
HINT: Use the same procedure for the intake side and exhaust side.
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connect
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during forward recognition camera removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Replaced
© 2023-2026 Copyright www.tocamry.com
