Toyota Camry (XV70): Precaution
PRECAUTION
PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.
|
System Name | See Procedure |
|---|---|
|
Lane Tracing Assist System |
|
|
Pre-collision System | |
|
Parking Assist Monitor System | |
|
Panoramic View Monitor System |
.gif)
IGNITION SWITCH EXPRESSIONS
(a) The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
|
Expression | Ignition Switch (Position) |
Engine Switch (Condition) |
|---|---|---|
|
Ignition Switch off |
LOCK | Off (Lock) |
|
Ignition Switch ACC |
ACC | On (ACC) |
|
Ignition Switch ON |
ON | On (IG) |
|
Engine Start | START |
On (Start) |
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION
*1 OUTER MIRROR SWITCH ASSEMBLY
*2 OUTER REAR VIEW MIRROR ASSEMBLY LH
*3 OUTER REAR VIEW MIRROR ASSEMBLY RH
*4 OUTER MIRROR LH
System Diagram
SYSTEM DIAGRAM ELECTRICAL REMOTE CONTROL MIRROR FUNCTION
MIRROR HEATER FUNCTION
Communication Table
Sender Receiver
Signal Communication Method
Air Conditioning C
System Description
SYSTEM DESCRIPTION POWER MIRROR CONTROL SYSTEM DESCRIPTION
(a) This system has the following functions: electrical remote control mirror function and mirror heater function.
FUNCTION OF MAIN COM
SEE MORE:
Remote Up / Down Function does not Operate
DESCRIPTION When the ignition switch is ON, the multiplex network master switch assembly sends remote up and down signals to each power window regulator motor assembly via LIN communication. WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
The power window control system uses the LIN comm
Components
COMPONENTS ILLUSTRATION
*1 CRANKSHAFT PULLEY
*2 TIMING CHAIN CASE OIL SEAL
*3 CRANKSHAFT PULLEY SET BOLT
*4 V-RIBBED BELT
N*m (kgf*cm, ft.*lbf): Specified torque
● Non-reusable part
MP grease -
-
© 2023-2026 Copyright www.tocamry.com
