Toyota Camry (XV70): Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
NOTICE:
- Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for navigation system or audio and visual system.
w/o Navigation System: Click here
.gif)
w/ Navigation System: Click here
- The following may occur if a radio and display receiver assembly from another vehicle is installed to this vehicle. Therefore, when replacing the radio and display receiver assembly, be sure to replace it with a new one.
- A communication malfunction DTC is stored.
- The radio and display receiver assembly does not operate normally.
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Clock System|
Symptom | Suspected Area |
Link |
|---|---|---|
| Clock (combination meter assembly) display is not displayed |
Combination meter assembly |
|
|
Clock (combination meter assembly) loses or gains time (Navigation system or audio and visual system is normal) |
Combination meter assembly |
|
|
Time setting |
| |
|
Clock (combination meter assembly) cannot be adjusted |
Combination meter assembly |
|
|
Clock (Radio and display receiver assembly) display is not displayed |
Radio and display receiver assembly |
|
|
Clock (Radio and display receiver assembly) loses or gains time (Other navigation system or audio and visual system functions is normal) |
Check customize parameters |
|
|
Radio and display receiver assembly |
| |
|
Clock (Radio and display receiver assembly) cannot be adjusted |
Check customize parameters |
|
|
Radio and display receiver assembly |
|
READ NEXT:
SEE MORE:
Engine (ignition) switch
(vehicles with a
smart key system)
Performing the following operations when carrying the electronic
key on your person starts the engine or changes engine
switch modes.
Starting the engine
1. Check that the parking brake is set.
2. Check that the shift lever is in P.
3. Firmly depress the brake pedal.
and a message will be di
High Beam Headlight Circuit
DESCRIPTION The main body ECU (multiplex network body ECU) controls the high beam headlights. WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following procedure.
Check the operation of the low beam headli
