Toyota Camry owners & service manuals

Toyota Camry (XV70): Radio Antenna Cord

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *A w/o Navigation Antenna *B w/ Navigation Antenna *1 ANTENNA CORD SUB-ASSEMBLY *2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY *3 N

 Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during a

 Installation

INSTALLATION PROCEDURE 1. INSTALL NO. 5 ANTENNA CORD SUB-ASSEMBLY (w/ Manual (SOS) Switch) (a) Engage the 5 clamps to install the No. 5 antenna cord sub-assembly. (b) Connect the connector. 2. INS

SEE MORE:

 Inspection

INSPECTION PROCEDURE 1. INSPECT FLOW SHUTTING VALVE (NO. 1 WATER BY-PASS HOSE) (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 - 2 20°C (68°F) 22 to 28 Ω

 Control Module Communication Bus "B" Off Bus Off (U007488,...,U015187)

DESCRIPTION The skid control ECU (brake actuator assembly) communicates with the following ECUs and sensors via CAN communication. ECM TCM (ECM) Yaw rate and acceleration sensor (airbag sensor assembly) Steering angle sensor Power steering ECU (rack and pinion power steering gea

© 2023-2026 Copyright www.tocamry.com