Toyota Camry (XV70): Rear Turn Signal Light Bulb
Toyota Camry Repair Manual XV70 (2018-2024) / Vehicle Exterior / Lighting (ext) / Rear Turn Signal Light Bulb
Replacement
REPLACEMENT
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE REAR COMBINATION LIGHT COVER
Click here .gif)
2. SEPARATE REAR COMBINATION LIGHT ASSEMBLY
Click here
3. REMOVE REAR TURN SIGNAL LIGHT BULB
Click here
4. INSTALL REAR TURN SIGNAL LIGHT BULB
Click here
5. INSTALL REAR COMBINATION LIGHT ASSEMBLY
Click here
6. INSTALL REAR COMBINATION LIGHT COVER
Click here
READ NEXT:
Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE
1. INSPECT H-LP LH RELAY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Con
Components
COMPONENTS ILLUSTRATION
*A for Type A
*B w/o Panoramic View Monitor System
*C w/ Panoramic View Monitor System
- -
*1 OUTER MIRROR
*2 OU
SEE MORE:
Battery
Check the battery as follows.
■ Battery exterior
Make sure that the battery terminals are not corroded and that
there are no loose connections, cracks, or loose clamps.
Terminals
Hold-down clamp
■Before recharging
When recharging, the battery produces hydrogen gas which is flammab
Yaw Rate Sensor Circuit Voltage Out of Range (C00631C)
DESCRIPTION The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.
The skid control ECU (brake actuator assembly) calibrates the sensitivity of the yaw rate sensor (airbag sensor assembly) based on signals from the steering angle sensor and sp
© 2023-2026 Copyright www.tocamry.com
