Toyota Camry owners & service manuals

Toyota Camry (XV70): Reassembly

REASSEMBLY

PROCEDURE

1. INSTALL SOLENOID (SL) VALVE

(a) Coat the solenoid (SL) valve with Toyota Genuine ATF WS.

(b) Install the solenoid (SL) valve to the transmission valve body assembly with the bolt.

Torque:

7.0 N

    READ NEXT:

     Installation

    INSTALLATION PROCEDURE 1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY (a) Coat 2 new transaxle case gaskets with Toyota Genuine ATF WS and install them to the automatic transaxle case sub-assembly. (

     Engine, Hybrid System

     2gr-fks (cooling)

    SEE MORE:

     Brake Actuator Operation Sound is Loud during Initial Check

    CAUTION / NOTICE / HINT NOTICE: After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and system information memorization. Click here PROCEDURE 1. PERFORM ROAD TEST (a) After turning the ignition switch to ON, compare

     Inspection

    INSPECTION PROCEDURE 1. INSPECT STARTER ASSEMBLY CAUTION: As a large electric current passes through the cable during this inspection, a thick cable must be used. If not, the cable may become hot and cause injury. NOTICE: Perform each of the following tests within 3 to 5 seconds to prevent the c

    © 2023-2025 Copyright www.tocamry.com