Toyota Camry (XV70): Inspection

Toyota Camry Repair Manual XV70 (2018-2024) / Engine, Hybrid System / A25a-fks (cooling) / Flow Shutting Valve (for Atf) / Inspection

INSPECTION

PROCEDURE

1. INSPECT FLOW SHUTTING VALVE (NO. 1 WATER BY-PASS HOSE)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
1 - 2	20°C (68°F)	22 to 28 Ω

If the result is not as specified, replace the flow shutting valve (No. 1 water by-pass hose).

*a	Component without harness connected (Flow Shutting Valve (No. 1 Water By-pass Hose))

SEE MORE:

Certification ECU Communication Stop Mode

DESCRIPTION Detection Item Symptom Trouble Area Certification ECU Communication Stop Mode Any of the following conditions are met: Communication stop for "Certification (Smart)" is indicated on the "Communication Bus Check" screen of the Techstream. Click here

Lost Communication with Alternator Missing Message (P161A87)

DESCRIPTION The ECM communicates with the generator assembly via LIN communication. If a LIN communication error is detected, the ECM stores this DTC. DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory Note P161A87 Lost Communicat

Toyota Camry (XV70): Inspection

READ NEXT:

Installation

Flow Shutting Valve(for Heater)

Components

SEE MORE:

Certification ECU Communication Stop Mode

Lost Communication with Alternator Missing Message (P161A87)