Toyota Camry owners & service manuals

Toyota Camry (XV70): Relay

Toyota Camry Repair Manual XV70 (2018-2024) / Vehicle Exterior / Window / Glass / Relay

On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT DEF RELAY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

3 - 4

Battery voltage applied between terminals 1 and 2

10 kΩ or higher

3 - 4

Battery voltage not applied between terminals

Below 1 Ω

3 - 5

Battery voltage applied between terminals 1 and 2

Below 1 Ω

3 - 5

Battery voltage not applied between terminals

10 kΩ or higher

4 - 5

Always

10 kΩ or higher

If the result is not as specified, replace the DEF relay.

    READ NEXT:

     Window Defogger System

     Precaution

    PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the

     Parts Location

    PARTS LOCATION ILLUSTRATION *1 DEF RELAY *2 REAR WINDOW DEFOGGER WIRE *3 ENGINE ROOM RELAY BLOCK AND JUNCTION BLOCK ASSEMBLY - DEF FUSE *4 BACK WINDOW

    SEE MORE:

     When the TRAC/VSC systems are operating - Driving assist systems

    The slip indicator light will flash while the TRAC/VSC systems are operating. Disabling the TRAC system If the vehicle gets stuck in mud, dirt or snow, the TRAC system may reduce power from the engine to the wheels. Pressing to turn the system off may make it easier for you to rock the vehi

     Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch

    DESCRIPTION If the manual up and down functions operate normally but the auto up and down functions do not, the power window control system may be in fail-safe mode. If power window initialization has not been performed, the auto up and down functions will not operate. Click here WIRING DIAG

    © 2023-2026 Copyright www.tocamry.com