Toyota Camry (XV70): Replacement
Toyota Camry Repair Manual XV70 (2018-2024) / Drivetrain / Gf1a (transfer / 4wd / Awd) / Transfer Oil / Replacement
REPLACEMENT
PROCEDURE
1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH
Click here .gif)
2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH
Click here
3. REMOVE NO. 1 ENGINE UNDER COVER
Click here
4. REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
Click here
5. DRAIN TRANSFER OIL
Click here
6. ADD TRANSFER OIL
Click here
7. INSPECT FOR TRANSFER OIL LEAK
8. INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
Click here
9. INSTALL NO. 1 ENGINE UNDER COVER
Click here
10. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
Click here
11. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
Click here
READ NEXT:
Transfer System
PrecautionPRECAUTION
PRECAUTION (a) Before disassembling the transfer assembly, thoroughly clean it to remove any foreign matter. This will help prevent contamination inside the transfer during disa
SEE MORE:
Intermediate Shaft Speed Sensor "A" Circuit Short to Battery (P079112,P079114,P079131)
DESCRIPTION The transmission revolution sensor (NC) detects the rotation speed of the counter gear which shows the output shaft speed of automatic transaxle assembly.
Based on the transmission revolution sensor (NC) signal and the transmission revolution sensor (NT) signal, the ECM controls engine
Terminals Of Ecu
TERMINALS OF ECU CLEARANCE WARNING ECU ASSEMBLY
(a) Disconnect the R39 clearance warning ECU assembly connector.
(b) Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below.
Terminal No. (Symbol) Terminal Description
Condit
© 2023-2026 Copyright www.tocamry.com
