Toyota Camry (XV70): Gf1a (transfer / 4wd / Awd)
Toyota Camry Repair Manual XV70 (2018-2024) / Drivetrain / Gf1a (transfer / 4wd / Awd)
- 4wd Control Ecu
- Dynamic Torque Control Awd System
- Transfer Assembly
- Transfer Case Front Oil Seal (for Lh Side)
- Transfer Case Front Oil Seal (for Rh Side)
- Transfer Oil
- Transfer System
READ NEXT:
4wd Control Ecu
ComponentsCOMPONENTS ILLUSTRATION
*1 NO. 3 INSTRUMENT PANEL TO COWL BRACE SUB-ASSEMBLY
*2 4WD ECU ASSEMBLY
N*m (kgf*cm, ft.*lbf): Specified torque
- - Rem
Precaution
PRECAUTION IGNITION SWITCH EXPRESSION HINT:
The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced starter assembly removal/installation are shown below. Necessary Procedures After Parts Removed/Installed/Rep
Installation
INSTALLATION PROCEDURE 1. INSTALL TIMING CHAIN COVER ASSEMBLY
(a) Clean the contact surfaces of the engine assembly, and confirm that no oil, moisture, or other foreign matter is on the surfaces.
*a Engine Assembly Side
*b Timing Chain Cover Assembly Side
Clean
© 2023-2026 Copyright www.tocamry.com
