Toyota Camry (XV70): Dynamic Torque Control Awd System
Toyota Camry Repair Manual XV70 (2018-2024) / Drivetrain / Gf1a (transfer / 4wd / Awd) / Dynamic Torque Control Awd System
- Precaution
- Parts Location
- System Diagram
- How To Proceed With Troubleshooting
- Calibration
- Problem Symptoms Table
- Terminals Of Ecu
- Dtc Check / Clear
- Freeze Frame Data
- Fail-safe Chart
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Linear Solenoid Power Supply System Malfunction (C120C)
- Low or High Power Supply Voltage (C1241)
- Engine Circuit Malfunction (C1280)
- ABS Malfunction (C1296)
- Steering Angle Sensor (C1297)
- Linear Solenoid Circuit (C1298)
- Cancellation of 4WD Control (C1299)
- Diameter of the Tire is not Uniform (C1337)
- Control Module Communication Bus Off (U0073,U0100,U0126,U0129)
- AWD Warning Remains ON
- AWD Warning does not Come ON
READ NEXT:
Precaution
PRECAUTION IGNITION SWITCH EXPRESSION HINT:
The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used
Parts Location
PARTS LOCATION ILLUSTRATION
*1 BRAKE ACTUATOR ASSEMBLY
- SKID CONTROL ECU *2
ECM *3
FRONT SPEED SENSOR LH
*4 FRONT SPEED SENSOR RH
*5 REAR SKID CONTR
System Diagram
SYSTEM DIAGRAM
SEE MORE:
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE OUTER MIRROR (for Type A)
Click here 2. REMOVE OUTER MIRROR COVER WITH OUTER MIRROR HOLE COVER (for Type A)
w/o Pan
TRAC does not Operate
DESCRIPTION When TRAC or VSC is operating, the skid control ECU (brake actuator assembly) blinks the slip indicator light to inform the driver that slippage occurred.
When in VSC off mode, or TRAC and VSC are disabled, the multi-information display in the combination meter assembly displays "Tract
© 2023-2026 Copyright www.tocamry.com
