Toyota Camry (XV70): Calibration
CALIBRATION
NOTICE:
- Initial AWD functions such as acceleration are sometimes affected unless backup memory is cleared.
- When the yaw rate and acceleration sensor (airbag sensor assembly) is replaced, Reset Memory must be performed.
RESET MEMORY
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) Enter the following menus: Chassis / Four Wheel Drive / Utility / Reset Memory.
Chassis > Four Wheel Drive > Utility
|
Tester Display |
| Reset Memory |
(f) Operate the Techstream to clear the data.
READ NEXT:
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order
TERMINALS OF ECU CHECK 4WD ECU ASSEMBLY
(a) Measure the voltage and resistance of the connector.
Terminal No. (Symbol) Wiring Color
Terminal Description Condition
Specified Cond
DTC CHECK / CLEAR CHECK DTC (a) Check the DTCs.
(1) Connect the Techstream to the DLC3. (2) Turn the ignition switch to ON.
(3) Turn the Techstream on. (4) Read the DTCs following the prompts on t
SEE MORE:
DESCRIPTION Refer to DTC C050612 Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
C050623 Right Front Wheel Speed Sensor Signal Stuck Low
When the vehicle is driven from 0 km/h to 12 km/h (0 mph to 7 mph), the wheel speed is 1.8 km/h (1.1
DESCRIPTION Refer to DTC C050612 Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
C14E314 Right Front Wheel Speed Sensor Supply Voltage Circuit Short to Ground or Open
An open or short in the speed sensor power supply circuit is detected for 0