Toyota Camry owners & service manuals

Toyota Camry (XV70): Dtc Check / Clear

DTC CHECK / CLEAR

CHECK DTC

(a) Check the DTCs.

(1) Connect the Techstream to the DLC3.

(2) Turn the ignition switch to ON.

(3) Turn the Techstream on.

(4) Read the DTCs following the prompts on the Techstream screen. Enter the following menus: Chassis / Four Wheel Drive / Trouble Codes.

Chassis > Four Wheel Drive > Trouble Codes

(5) Check the details of the DTCs.

Click here

CLEAR DTC

(a) Clear the DTCs.

(1) Connect the Techstream to the DLC3.

(2) Turn the ignition switch to ON.

(3) Turn the Techstream on.

(4) Operate the Techstream to clear the DTCs. Enter the following menus: Chassis / Four Wheel Drive / Trouble Codes.

Chassis > Four Wheel Drive > Clear DTCs

(5) According to the display on the Techstream, select the trouble code data display with the clear button.

    READ NEXT:

     Freeze Frame Data

    FREEZE FRAME DATA FREEZE FRAME DATA (a) When a DTC is stored, the 4WD ECU assembly stores the current vehicle state as Freeze Frame Data. HINT: Freeze Frame Data at the time a DTC is stored: Wh

     Fail-safe Chart

    FAIL-SAFE CHART FAIL-SAFE CHART Dynamic Torque Control AWD System DTC No. Trouble Area AWD Warning Message Fail-safe Operation Memory Fail-safe Deactivation Condition C12

     Data List / Active Test

    DATA LIST / ACTIVE TEST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faul

    SEE MORE:

     Lost Communication with EMV Missing Message (B132187)

    DESCRIPTION The meter mirror sub-assembly receives signals from the radio and display receiver assembly via local bus communication and navigation system information on the headup display. This DTC is stored when the meter mirror sub-assembly cannot receive the signal. DTC No. Detection Item

     Removal

    REMOVAL PROCEDURE 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM Click here 2. REMOVE V-RIBBED BELT Click here 3. REMOVE COOL AIR INTAKE DUCT SEAL Click here 4. REMOVE INLET AIR CLEANER ASSEMBLY Click here 5. DISCONNECT NO. 5 WATER BY-PASS HOSE Click here 6. DISCONNECT NO. 1 COOLE

    © 2023-2026 Copyright www.tocamry.com