Toyota Camry (XV70): Data List / Active Test
DATA LIST / ACTIVE TEST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
DATA LIST OF 4WD ECU ASSEMBLY
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / Four Wheel Drive / Data List.
(e) According to the display on the Techstream, read the Data List.
Chassis > Four Wheel Drive > Data List|
Tester Display | Measurement Item |
Range | Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
4WD Warning Light | AWD warning (multi-information display) |
OFF or ON | OFF: Warning off ON: Warning on | - |
|
Stop Light SW | Stop light switch |
OFF or ON | OFF: Brake pedal released ON: Brake pedal depressed |
- |
| Forward and Rearward G |
Forward and Rearward G |
Min.: -25.10 m/s2 Max.: 24.90 m/s2 |
Approximately 0 +/-0.13 m/s2 while stationary |
Changes in proportion with acceleration during acceleration/deceleration. |
|
Steering Angle Value | Steering angle value |
Min.: -3276.8 |
READ NEXT:
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Dynamic Torque Control AWD System
DTC No. Detection Item
Link C120C
Linear Solenoid Power Supply System Malfunction
C1241 Low or
Linear Solenoid Power Supply System Malfunction (C120C)
DESCRIPTION This DTC is output by the 4WD ECU assembly if a malfunction occurs in the linear solenoid power supply system.
DTC No. Detection Item
DTC Detection Condition Trouble Area
Low or High Power Supply Voltage (C1241)
DESCRIPTION If a malfunction in the power source circuit occurs, or a malfunction in communication with the skid control ECU (brake actuator assembly) or in a speed sensor occurs, the 4WD ECU assembly
SEE MORE:
Ambient Temperature Display System
DESCRIPTION The thermistor assembly is installed in front of the cooler condenser assembly to detect the ambient temperature, which is used to control the automatic air conditioning system. The thermistor assembly detects fluctuations in the ambient temperature and sends it as a signal to the combin
Maintenance data (fuel, oil level, etc.)
Dimensions and weights (2WD models)
*1: Unladen vehicles
*2: For LE or XLE grade models
*3: For SE or XSE grade models
*4: 205/65R16 tires
*5: 215/55R17 tires and TRD models with 235/40R19 tires
*6: 235/45R18, and SE or XSE grade models with 235/40R19 tires
*7: For TRD models
Dimensions an
