Toyota Camry (XV70): System Diagram
SYSTEM DIAGRAM
READ NEXT:
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure listed to troubleshoot the Dynamic Torque Control AWD System.
*: Use the Techstream.
PROCEDURE
1. VEHICLE BROUGHT TO W
Calibration
CALIBRATION
NOTICE:
Initial AWD functions such as acceleration are sometimes affected unless backup memory is cleared.
When the yaw rate and acceleration sensor (airbag sensor assembly) is
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order
SEE MORE:
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL OIL PUMP ROTOR SET
(a) Coat the drive rotor and driven rotor with engine oil and place them into the timing chain cover assembly with the rotor marks facing up. Check that the rotors rotate smoothly.
*a Rotor Mark
2. I
Linear Solenoid Circuit (C1298)
DESCRIPTION The 4WD ECU assembly receives signals from each sensor to control clutch fluid pressure for limiting the center differential operation, which distributes torque according to the driving conditions.
DTC No. Detection Item
DTC Detection Condition Trouble Area
C1298
© 2023-2025 Copyright www.tocamry.com
