Toyota Camry (XV70): How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
- Use the following procedure listed to troubleshoot the Dynamic Torque Control AWD System.
- *: Use the Techstream.
PROCEDURE
|
1. | VEHICLE BROUGHT TO WORKSHOP |
|
| 2. |
INSPECT BATTERY VOLTAGE |
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
|
| 3. |
CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
(a) Use the Techstream to check if the CAN communication system is functioning normally.
Click here .gif)
|
Result | Proceed to |
|---|---|
|
CAN DTC is not output |
A |
| CAN DTC is output |
B |
| B |
 | GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) |
|
| 4. |
CHECK DTC AND FREEZE FRAME DATA* |
(a) Check for DTCs.
Chassis > Four Wheel Drive > Trouble Codes(b) Check for freeze frame data.
HINT:
Record or print DTCs and freeze frame data if necessary.
(c) Clear the DTCs and freeze frame data.
Chassis > Four Wheel Drive > Clear DTCs(d) Recheck for DTCs.
Chassis > Four Wheel Drive > Trouble Codes|
Result | Proceed to |
|---|---|
|
DTC does not reoccur | A |
|
DTC reoccurs | B |
| B |
| GO TO STEP 7 |
|
| 5. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table.
Click here
|
Result | Proceed to |
|---|---|
|
Fault not listed in problem symptoms table |
A |
| Fault listed in problem symptoms table |
B |
| B |
| GO TO STEP 7 |
|
| 6. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Terminals of ECU.
Click here
(b) Data List / Active Test.
Click here
|
| 7. |
REPAIR OR REPLACE |
|
| 8. |
CONFIRMATION TEST |
| NEXT | | END |
READ NEXT:
Calibration
CALIBRATION
NOTICE:
Initial AWD functions such as acceleration are sometimes affected unless backup memory is cleared.
When the yaw rate and acceleration sensor (airbag sensor assembly) is
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order
Terminals Of Ecu
TERMINALS OF ECU CHECK 4WD ECU ASSEMBLY
(a) Measure the voltage and resistance of the connector.
Terminal No. (Symbol) Wiring Color
Terminal Description Condition
Specified Cond
SEE MORE:
Lost Communication with Sliding Sunshade ECU (B2329)
DESCRIPTION This DTC is stored when LIN communication between the roof sunshade ECU (sliding roof drive gear assembly) and main body ECU (multiplex network body ECU) stops for 10 seconds or more.
DTC No. Detection Item
DTC Detection Condition Trouble Area
B2329 Lost Communic
Trailer towing
Toyota does not recommend towing a trailer with your vehicle.
Toyota also does not recommend the installation of a tow hitch
or the use of a tow hitch carrier for a wheelchair, scooter, bicycle,
etc. Your vehicle is not designed for trailer towing or for the
use of tow hitch mounted carriers.
