Toyota Camry (XV70): Solar Sensor
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 AUTOMATIC LIGHT CONTROL SENSOR
*2 DEFROSTER NOZZLE ASSEMBLY
*3 NO. 1 SIDE DEFROSTER NOZZLE DUCT
*4 NO. 2 SIDE DEFROSTER NOZZLE DUCT
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during au
Inspection
INSPECTION PROCEDURE 1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR
(a) Disconnect the M1 automatic light control sensor connector.
*a Front view of wire harness connector
SEE MORE:
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE CYLINDER BOOT
(a) Using a screwdriver with its tip wrapped with protective tape, remove the rear disc brake piston set ring and cylinder boot from the rear disc brake cylinder.
NOTICE: Be careful not to damage the rear disc brake piston and rear disc brake cy
Reassembly
REASSEMBLY PROCEDURE 1. BEARING POSITION
Check bearing position and installation direction.
Thrust Needle Roller Bearing and Bearing Race Diameter:
Mark Front Side Thrust Bearing Race Diameter Inside / Outside
mm (in.) Thrust Bearing Diameter Inside / Outside
mm (in.) Rear
© 2023-2026 Copyright www.tocamry.com
