Toyota Camry (XV70): Steering Angle Sensor (C1A47)
DESCRIPTION
The blind spot monitor sensor receives steering angle signals from the steering sensor via CAN communication.
Blind Spot Monitor Master|
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
|---|---|---|---|
|
C1A47 | Steering Angle Sensor |
A fail flag is transmitted from the steering angle sensor |
|
|
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
|---|---|---|---|
|
C1A47 | Steering Angle Sensor |
A fail flag is transmitted from the steering angle sensor |
|
CAUTION / NOTICE / HINT
NOTICE:
When checking for DTCs, make sure that the blind spot monitor system is turned on.
PROCEDURE
| 1. |
CHECK DTC |
(a) Turn the engine switch off.
(b) Turn the engine switch on (IG).
(c) Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble CodesOK:
No DTCs are output.
| OK | .gif) |
USE SIMULATION METHOD TO CHECK |
|
.gif)
| 2. |
REPLACE STEERING SENSOR |
(a) Replace the steering sensor with a new or known good one.
Click here .gif)
|
| 3. |
RECHECK DTC |
(a) Turn the engine switch off.
(b) Turn the engine switch on (IG).
(c) Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble Codes|
Result | Proceed to |
|---|---|
|
No DTCs are output | A |
|
DTC C1A47 is output ("Blind Spot Monitor Master") |
B |
| DTC C1A47 is output ("Blind Spot Monitor Slave") |
C |
| A |
| END |
| B |
| REPLACE BLIND SPOT MONITOR SENSOR RH
|
| C |
| REPLACE BLIND SPOT MONITOR SENSOR LH
|
READ NEXT:
Short to +B in Outer Mirror Indicator(Master) (C1AB0)
DESCRIPTION This DTC is stored when the blind spot monitor sensor RH detects a short to +B in the outer rear view mirror indicator RH.
DTC No. Detection Item
DTC Detection Condition Tro
Short to +B in Outer Mirror Indicator(Slave) (C1AB1)
DESCRIPTION This DTC is stored when the blind spot monitor sensor LH detects a short to +B in the outer rear view mirror indicator LH.
DTC No. Detection Item
DTC Detection Condition Tro
Short to GND in Outer Mirror Indicator(Master) (C1AB2)
DESCRIPTION This DTC is stored when the blind spot monitor sensor RH detects a short to ground in the outer rear view mirror indicator RH.
DTC No. Detection Item
DTC Detection Condition
SEE MORE:
Auto ID Under Registration (C2128)
DESCRIPTION When ID registration is being performed via the automatic ID registration function, the tire pressure warning ECU and receiver stores C2128 and the tire pressure warning light flashes for 1 minute and then illuminates.
When the tire pressure warning ECU receives data from all registere
Vehicle Control History
VEHICLE CONTROL HISTORY NOTICE: Make sure to record any output Vehicle Control History codes before clearing them and checking the Vehicle Control History again.
CHECK VEHICLE CONTROL HISTORY NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing init
