Toyota Camry (XV70): Park Assist / Monitoring
Toyota Camry Repair Manual XV70 (2018-2024) / Audio, Visual, Telematics / Park Assist / Monitoring
- Blind Spot Monitor Sensor
- Blind Spot Monitor System
- Clearance Warning Buzzer
- Clearance Warning Ecu
- Intuitive Parking Assist System
READ NEXT:
Blind Spot Monitor Sensor
ComponentsCOMPONENTS ILLUSTRATION
*1 BLIND SPOT MONITOR SENSOR LH
*2 BLIND SPOT MONITOR SENSOR RH
*3 REAR BUMPER ASSEMBLY
- -
N*m (kgf*cm, ft.*lbf)
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the c
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during heated oxygen sensor removal/installation are shown below. Necessary Procedures After Parts Removed/In
Reassembly
REASSEMBLY PROCEDURE 1. CLEAN VACUUM PUMP HOUSING
(a) Clean the inside surface of the vacuum pump housing. 2. INSTALL VACUUM PUMP ROTOR
(a) Clean the vacuum pump rotor. (b) Apply engine oil to the areas of the vacuum pump rotor shown in the illustration.
Engine Oil (c) Instal
© 2023-2026 Copyright www.tocamry.com
