Toyota Camry owners & service manuals

Toyota Camry (XV70): Voice is not Recognized

PROCEDURE

1.

CHECK CONDITION

(a) While paying attention to the condition of the spoken voice command, perform a voice recognition operation.

OK:

Voice command is recognized normally.

HINT:

  • When the voice command is recognized, the content of the voice command is displayed in the voice recognition result display area to the right of the mic icon. (Example: When "Cancel" is spoken, "Cancel" is displayed in the voice recognition result display area.)
  • If an unnecessary word (such as "um" or "ah") is spoken before or after the recognition word, the system incorrectly recognizes the recognition word.
  • The system cannot recognize voice commands when multiple people are speaking simultaneously.
  • If the speaking speed is too fast or too slow, the recognition rate may decrease.
  • The system may have difficulty recognizing voice commands depending on the voice quality (such as a hoarse voice due to poor physical condition).
OK

END (VOICE RECOGNITION MAY BE DIFFICULT DUE TO SPEECH CONDITION)

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

    READ NEXT:

     Cellular Phone Registration Failure

    CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to

     Cellular Phone Inspection

    PROCEDURE 1. CHECK USAGE CONDITION (a) Check that the vehicle and cellular phone meet the following conditions: NOTICE: If changing cellular phone settings, updating software, etc. is

     Sound of Portable Player cannot be Heard from Speakers or Sound is Low

    PROCEDURE 1. CHECK PORTABLE PLAYER SETTINGS (a) Check the portable player settings. (1) Check that the volume is not set to "0". (2) Check that mute is off. (b) Check that the sound of

    SEE MORE:

     USB charging ports

    The USB charging ports are used to supply 2.5 A (USB Type-A port) or 3.0 A (USB Type-C port) of electricity at 5 V to external devices. The USB charging ports are for charging only. They are not designed for data transfer or other purposes. Depending on the external device, it may not charge

     Fuel Rail Pressure Sensor (Low) Signal Stuck in Range (P107A2A,P107A64)

    DESCRIPTION Refer to DTC P107A11. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P107A2A Fuel Rail Pressure Sensor (Low) Signal Stuck in Range When target low pressure side fuel pressure changes, the change in fue

    © 2023-2026 Copyright www.tocamry.com