Toyota Camry (XV70): Weather and traffic information cannot be obtained
CAUTION / NOTICE / HINT
NOTICE:
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
- A communication malfunction DTC may be stored.
- The radio and display receiver assembly may not operate normally.
HINT:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click here .gif)
PROCEDURE
| 1. |
CHECK COVERAGE AREA |
(a) w/ Manual (SOS) Switch: Check that the current position of the vehicle is within the HD weather and traffic or DCM communication function coverage area.
w/o Manual (SOS) Switch: Check that the current position of the vehicle is within the HD weather and traffic coverage area.
OK:
Vehicle is within coverage area.
| NG | .gif) | MOVE TO WITHIN COVERAGE AREA |
|
.gif)
| 2. |
CHECK SYMPTOMS |
(a) Check for symptoms (poor sound quality, sounds cannot be heard, etc.) during conventional FM radio broadcasting.
|
Result | Proceed to |
|---|---|
|
Symptoms occur | A |
|
Symptoms do not occur |
B |
| A |
| GO TO "RADIO BROADCAST CANNOT BE RECEIVED OR POOR RECEPTION" IN PROBLEM SYMPTOMS TABLE
|
|
| 3. |
CHECK SYMPTOMS |
(a) Check for symptoms (Unable to connect to call center, etc.) with an ordinary safety connect.
|
Result | Proceed to |
|---|---|
|
Symptoms occur | A |
|
Symptoms do not occur |
B |
| A |
| GO TO "UNABLE TO CONNECT TO CALL CENTER" IN PROBLEM SYMPTOMS TABLE
|
| B |
| REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY
|
READ NEXT:
Noise Occurs
PROCEDURE
1. CHECK NOISE CONDITION
(a) Check from which direction the noise comes (front left or right, or rear left or right).
OK: The location of the noise source can be determined.
No Sound can be Heard from Speakers
PROCEDURE
1. CHECK AUDIO SETTINGS
(a) In sound output setting mode, set volume, fader and balance to the initial values and check that the sound is normal.
OK: Audio system returns to
Radio Broadcast cannot be Received or Poor Reception
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to
SEE MORE:
Functions included in LTA system - LTA (Lane Tracing
Assist)
◆ Lane departure alert function
When the system determines
that the vehicle might depart
from its lane or course*, a
warning is displayed on the
multi-information display, and a
warning buzzer will sound to
alert the driver.
When the warning buzzer
sounds, check the area around
your ve
Terminals Of Ecu
TERMINALS OF ECU CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
*A w/o Seat Heater
*B w/ Seat Heater
*C for Dual Type
*D for Single Type
HINT:
Check from the rear of the connector while it is connected to the air conditioning amplifier assembly.
Make sure to wait
