Toyota Camry (XV70): Wiper Switch
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 LOWER STEERING COLUMN COVER SUB-ASSEMBLY
*2 UPPER STEERING COLUMN COVER
*3 WINDSHIELD WIPER SWITCH ASSEMBLY
- -
Removal
REMOVAL PROCEDURE 1. REMOVE LOWER STEERING COLUMN COVER SUB-ASSEMBLY
NOTICE: Removing the lower steering column cover sub-assembly in the incorrect order will cause the parts to break.
(a) Release
Inspection
INSPECTION PROCEDURE 1. INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance: Front Wiper Switch
Teste
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY
NOTICE: If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one.
(a) Engage the 2 guides.
Bolt
Screw (b) In
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear upper control arm assembly removal/installation are shown below. Necessary Procedures After Part
© 2023-2026 Copyright www.tocamry.com
