Toyota Camry owners & service manuals

Toyota Camry (XV70): Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. TEMPORARILY INSTALL REAR AXLE CARRIER SUB-ASSEMBLY

(a) Temporarily install the rear axle carrier sub-assembly to the rear shock absorber assembly with the nut and plate washer.

NOTICE:

Hold the rear axle carrier pin while rotating the nut.

(b) Temporarily install the rear axle carrier sub-assembly to the rear upper control arm assembly with the bolt and nut.

NOTICE:

  • Insert the bolt with the threaded end facing the rear of the vehicle.
  • Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

(c) Install the rear trailing arm assembly to the rear axle carrier sub-assembly with the 2 bolts.

Torque:

135 N

    READ NEXT:

     Rear Axle Carrier (for Awd)

     Components

    COMPONENTS ILLUSTRATION *1 NO. 2 PARKING BRAKE WIRE ASSEMBLY *2 REAR AXLE HUB AND BEARING ASSEMBLY *3 REAR AXLE SHAFT NUT *4 REAR DISC *5 REAR DISC BRAK

     Removal

    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during r

    SEE MORE:

     Tire And Wheel

    ComponentsCOMPONENTS ILLUSTRATION *A for Steel Wheel *B except Steel Wheel *1 WHEEL ASSEMBLY *2 AXLE HUB NUT *3 WHEEL CAP - - Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping"

     Removal

    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission valve body assembly removal/installation are shown below. Necessary Procedures After Part

    © 2023-2026 Copyright www.tocamry.com