Toyota Camry (XV70): Back-up Light Bulb
Toyota Camry Repair Manual XV70 (2018-2024) / Vehicle Exterior / Lighting (ext) / Back-up Light Bulb
Replacement
REPLACEMENT
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE LUGGAGE COMPARTMENT DOOR COVER
Click here .gif)
2. REMOVE BACK-UP LIGHT BULB
Click here
3. INSTALL BACK-UP LIGHT BULB
Click here
4. INSTALL LUGGAGE COMPARTMENT DOOR COVER
Click here
READ NEXT:
Front Side Marker Light Bulb
ReplacementREPLACEMENT CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE FRONT SIDE M
Front Turn Signal Light Bulb
ReplacementREPLACEMENT CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE FRONT TURN S
Hazard Warning Switch
ComponentsCOMPONENTS ILLUSTRATION
*A for 7 Inch Display
*B for 9 Inch Display
*1 CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
*2 CENTER INSTRUMENT CLUSTE
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during brake actuator assembly removal/installation are shown below. Necessary Procedures After Parts Removed
Parts Location
PARTS LOCATION ILLUSTRATION
*1 FRONT ENGINE MOUNTING INSULATOR
*2 REAR ENGINE MOUNTING INSULATOR
*3 CANISTER
*4 FUEL PUMP (for Low Pressure Side)
*5 MASS AIR FLOW METER SUB-ASSEMBLY
*6 PARK / NEUTRAL POSITION SWITCH ASSEMBLY
*7 VACUUM
© 2023-2026 Copyright www.tocamry.com
