Toyota Camry (XV70): Black Screen
PROCEDURE
|
1. | CHECK DISPLAY SETTING |
(a) Check that the display is not in screen off mode.
OK:
The display setting is not in screen off mode.
| NG | .gif) | CHANGE SCREEN TO SCREEN ON MODE |
|
.gif)
| 2. |
CHECK IMAGE QUALITY SETTING |
(a) Check that the screen color quality can be set.
OK:
Setting is possible.
| OK | |
SET SCREEN COLOR QUALITY TO NORMAL |
| NG | | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE
|
.gif)
READ NEXT:
Vehicle Speed Signal Circuit between Radio Receiver and Combination Meter
DESCRIPTION for Automatic Sound Levelizer (ASL):
This circuit is necessary for the Automatic Sound Levelizer (ASL) built into the radio and display receiver assembly.
The Automatic Sound Leveli
Steering Pad Switch Circuit
DESCRIPTION This circuit sends an operation signal from the steering pad switch assembly to the radio and display receiver assembly.
If there is an open in the circuit, the audio system cannot be op
Illumination Circuit
DESCRIPTION Power is supplied to the radio and display receiver assembly and steering pad switch assembly illumination when the light control switch is in the tail or head position. WIRING DIAGRAM
SEE MORE:
Pressure Control Solenoid "A" Circuit Short to Battery (P074512)
DESCRIPTION Changing gears is performed by the ECM turning the solenoid (SL1, SL2, SL3, SL4, SL5 and SL6) valves on and off.
If an open or short occurs in any of the solenoid valve circuits, the ECM controls the remaining normal solenoid valves to allow the vehicle to be driven. If all of the sole
RCTA (Rear Cross Traffic
Alert)
The RCTA function uses the BSM rear side radar sensors
installed behind the rear bumper. This function is intended to
assist the driver in checking areas that are not easily visible
when backing up.
System components
Multi-information display
Turning the RCTA function on/off.
Outside r
© 2023-2026 Copyright www.tocamry.com
