Toyota Camry (XV70): On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. FUEL PUMP ASSEMBLY OPERATION
(a) Check fuel pressure.
(1) Connect the Techstream to the DLC3.
(2) Start the engine.
(3) Turn the Techstream on.
(4) Enter the following menus: Powertrain / Engine / Active Test / Control the Target Fuel Pressure Offset.
Powertrain > Engine > Active Test|
Active Test Display |
|---|
|
Control the Target Fuel Pressure Offset |
|
Data List Display |
|---|
|
Fuel Pressure (High) |
(5) Select the Data List item: Fuel Pressure (High)
(6) Check that the fuel pressure fluctuates when the target fuel pressure changes.
HINT:
The target fuel pressure operation decreases the target fuel pressure by 12.5% or increases the target fuel pressure by 24.8%.
If the result is not as specified, replace the fuel pump assembly or fuel pressure sensor (fuel delivery pipe with sensor assembly LH).
(b) Check operating sound.
(1) Remove the cowl top ventilator louver sub-assembly.
Click here .gif)
(2) Remove the front center upper suspension brace sub-assembly.
Click here
(3) Start the engine.
(4) Using a sound scope, check the operating sound of the fuel pump assembly.
If no sound can be heard, check the fuel pump assembly, wire harness and ECM.
(5) Stop the engine.
(6) Install the front center upper suspension brace sub-assembly.
Click here
(7) Install the cowl top ventilator louver sub-assembly.
Click here
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fu
Inspection
INSPECTION PROCEDURE 1. INSPECT FUEL PUMP ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
Sp
Installation
INSTALLATION PROCEDURE 1. TEMPORARILY INSTALL FUEL (ENGINE ROOM SIDE) PUMP ASSEMBLY
(a) Turn the crankshaft pulley until the flat of the camshaft faces the fuel pump lifter assembly.
HINT: Th
SEE MORE:
Components
COMPONENTS ILLUSTRATION
*1 NO. 2 PARKING BRAKE WIRE ASSEMBLY
*2 REAR DISC BRAKE ANTI-SQUEAL SHIM KIT
*3 REAR DISC BRAKE PAD
*4 REAR DISC BRAKE CYLINDER ASSEMBLY
*5 REAR NO. 1 DISC BRAKE ANTI-SQUEAL SHIM
*6 REAR NO. 2 DISC BRAKE ANTI-SQUEAL SHIM
Red Indicator Remains On
DESCRIPTION This means that the DCM (telematics transceiver) has detected a malfunction in the safety connect system and stored a DTC or specific vehicle control history (RoB) Code. PROCEDURE
1.
CHECK DTC (a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3. (c) Tur
