Toyota Camry (XV70): Brake Fluid
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY
- - ILLUSTRATION
*A except 2-Pot Caliper
*B for 2-Pot Caliper
*C w/o
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT BRAKE FLUID LEVEL IN RESERVOIR
(a) Check the fluid level. If the brake fluid level is lower than the MIN line, inspect for brake fluid leaks and brak
Replacement
REPLACEMENT CAUTION / NOTICE / HINT
Click here
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front drive shaft assembly removal/installation are shown below. Necessary Procedures After Parts Rem
Inspection
INSPECTION PROCEDURE 1. INSPECT VSC OFF SWITCH
(a) Make sure that there is no looseness at the locking part and the connecting part of the connector.
OK: The connector is securely connected.
*a Component without harness connected
(VSC OFF switch)
© 2023-2025 Copyright www.tocamry.com
