Toyota Camry (XV70): Brake System (other)
READ NEXT:
COMPONENTS ILLUSTRATION
*1 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
- - ILLUSTRATION
*1 FRONT CENTER UPPER SUSPENSION BRACE SUB-ASSEMBLY
- -
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT BRAKE BOOSTER ASSEMBLY (a) Airtightness check
(1) Start the engine and stop it after 1 or 2 minutes. Slowly depress the brake pedal several times.
SEE MORE:
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front door belt moulding removal/installation are shown below. Necessary Procedure After Parts Remove
INSTALLATION PROCEDURE 1. INSTALL NO. 2 CYLINDER HEAD GASKET
(a) Place a new No. 2 cylinder head gasket on the cylinder block sub-assembly as shown in the illustration.
*a Lot No.
Front of Engine
NOTICE:
Remove any oil from the contact surfaces.
Make sure t