Toyota Camry (XV70): Vacuum Pump (for 2gr-fks)
READ NEXT:
COMPONENTS ILLUSTRATION
*1 ENGINE WIRE
*2 NO. 2 SURGE TANK STAY
*3 EARTH WIRE
- -
Tightening torque for "Major areas involving basic vehicle perfor
ON-VEHICLE INSPECTION PROCEDURE
1. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Click here
2. REMOVE FRONT CENTER UPPER SUSPENSION BRACE SUB-ASSEMBLY
Click here
3. OPERATION CHECK (a) S
REMOVAL PROCEDURE 1. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
Click here 2. REMOVE NO. 2 SURGE TANK STAY
Click here
3. SEPARATE ENGINE WIRE
(a) Remove the 2 bolts and separate the eng
SEE MORE:
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front axle hub sub-assembly removal/installation are shown below. Necessary Procedures After Parts Re
TERMINALS OF ECU TERMINALS OF ECU
*a Component without harness connected
(Rack and Pinion Power Steering Gear Assembly)
- -
HINT:
The rack and pinion power steering gear assembly uses waterproof connectors. Therefore, voltage or waveforms cannot be checked wit