Toyota Camry (XV70): Installation
INSTALLATION
PROCEDURE
1. INSTALL VACUUM PUMP ASSEMBLY
(a) Clean the vacuum pump assembly installation bolt holes in the camshaft housing sub-assembly and cylinder head sub-assembly.
(b) When using a new vacuum pump assembly:
(1) Apply engine oil to the 2 O-rings which are installed to a new vacuum pump assembly.
.png) |
Engine oil |
(c) When reusing the vacuum pump assembly:
(1) Apply engine oil to 2 new O-rings and install them to the vacuum pump assembly.
|
|
Engine oil |
(d) Apply engine oil to the inner surface of the installation hole.
| (e) Temporarily install the vacuum pump assembly so that the oil pipe engages with the hole of the camshaft and the coupling teeth engages with the groove of the camshaft. NOTICE:
|
|
| (f) Install the vacuum pump assembly with 3 new bolts. Torque: 21 N |
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 ENGINE WIRE
*2 NO. 1 VACUUM HOSE CONNECTOR
*3 VACUUM PUMP ASSEMBLY
*4 NO. 1 VACUUM PUMP O-RING
Tightening torque for "Ma
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE
1. OPERATION CHECK (a) Slide the clip and disconnect the union to check valve hose from the vacuum pump assembly.
(b) Connect the hose of the vacuum gauge to th
SEE MORE:
Components
COMPONENTS ILLUSTRATION
*A except 2-Pod Caliper
*B for 2-Pod Caliper
*1 FRONT AXLE ASSEMBLY
*2 FRONT AXLE SHAFT NUT
*3 FRONT DISC
*4 FRONT DISC BRAKE CALIPER ASSEMBLY
*5 FRONT DRIVE SHAFT ASSEMBLY
*6 FRONT LOWER NO. 1 SUSPENSI
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the GTS to the DLC3.
(b) Turn the ignition switch to ON. (c) Turn the intuitive parking assist system on.
(d) Turn the GTS on. (e) Enter the following menus: Body Electrical / Clearance Warning / Trouble Codes.
(f) Check for DTCs. Body Electrical > Cl
