Toyota Camry (XV70): Vacuum Warning Switch
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 CHECK VALVE GROMMET
*2 VACUUM WARNING SWITCH ASSEMBLY
● Non-reusable part
- -
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT BRAKE FLUID LEVEL IN RESERVOIR Click here
2. INSPECT BRAKE BOOSTER ASSEMBLY
Click here 3. INSPECT VACUUM WARNING SWITCH ASSEMBLY
(a) Start the en
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during va
SEE MORE:
Right Front Wheel Speed Sensor Supply Voltage Circuit Short to Ground or Open (C14E314)
DESCRIPTION Refer to DTC C050612 Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
C14E314 Right Front Wheel Speed Sensor Supply Voltage Circuit Short to Ground or Open
An open or short in the speed sensor power supply circuit is detected for 0
Installation
INSTALLATION PROCEDURE 1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY
(a) Pass the hood lock control cable assembly into the engine compartment.
(b) Engage the grommet. (c) Engage the 4 clamps to install the hood lock control cable assembly.
(d) Engage the clamp. 2. INSTALL HOOD LOCK CONTROL L
© 2023-2026 Copyright www.tocamry.com
