Toyota Camry owners & service manuals

Toyota Camry (XV70): On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT BRAKE FLUID LEVEL IN RESERVOIR

Click here

2. INSPECT BRAKE BOOSTER ASSEMBLY

Click here

3. INSPECT VACUUM WARNING SWITCH ASSEMBLY

(a) Start the engine and stop it after 1 or 2 minutes.

(b) Remove the battery.

for A25A-FKS: Click here

for 2GR-FKS: Click here

(c) Disconnect the connector from the vacuum warning switch assembly.

(d) Measure the resistance of the vacuum warning switch assembly.

Standard Resistance:

10 kΩ or higher

(e) With the engine stopped, depress the brake pedal several times to release vacuum from the brake booster assembly, and measure the resistance of the vacuum warning switch assembly.

Standard Resistance:

Below 1 Ω

(f) Connect the connector to the vacuum warning switch assembly.

(g) Install the battery.

for A25A-FKS: Click here

for 2GR-FKS: Click here

    READ NEXT:

     Removal

    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during va

     Installation

    INSTALLATION PROCEDURE 1. INSTALL CHECK VALVE GROMMET (a) Install a new check valve grommet to the brake booster assembly. 2. INSTALL VACUUM WARNING SWITCH ASSEMBLY (a) Install the vacuum warning

     Parking Brake

    SEE MORE:

     Left Rear Wheel Speed Sensor Supply Voltage Circuit Short to Ground or Open (C14E614)

    DESCRIPTION Refer to DTC C050C12 Click here DTC No. Detection Item DTC Detection Condition Trouble Area C14E614 Left Rear Wheel Speed Sensor Supply Voltage Circuit Short to Ground or Open An open or short in the speed sensor power supply circuit is detected for 0.1

     Fuel Pump Control Circuit

    DESCRIPTION The fuel pump (for low pressure side) circuit consists of the ECM, fuel pump (for low pressure side) and fuel pump control ECU (which operates the fuel pump (for low pressure side)). Based on the engine output, the ECM determines the fuel pump speed. The speed is then converted to a duty

    © 2023-2026 Copyright www.tocamry.com