Toyota Camry (XV70): Components
COMPONENTS
ILLUSTRATION
|
*1 | REAR DISC BRAKE ANTI-SQUEAL SHIM KIT |
*2 | REAR DISC BRAKE PAD |
|
*3 | REAR DISC BRAKE CYLINDER ASSEMBLY |
*4 | REAR DISC BRAKE PAD WEAR INDICATOR PLATE |
|
*5 | REAR NO. 1 DISC BRAKE ANTI-SQUEAL SHIM |
*6 | REAR FLEXIBLE HOSE |
.png) |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
.png) |
Brake shim grease (Part No. 08887-80409) |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT
NOTICE:
Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to
Installation
INSTALLATION CAUTION / NOTICE / HINT
NOTICE:
Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attentio
Rear Side Marker Light Bulb
ComponentsCOMPONENTS ILLUSTRATION
*1 REAR COMBINATION LIGHT ASSEMBLY
*2 REAR COMBINATION LIGHT COVER
*3 REAR SIDE MARKER LIGHT BULB
- - RemovalREMOVAL CAUTION
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT TIE ROD ASSEMBLY LH
(a) Secure the tie rod assembly LH in a vise between aluminum plates.
NOTICE: Do not overtighten the vise.
(b) Install the nut to the stud bolt. (c) Flip the ball joint back and forth 5 times.
(d) Using a torque wr
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT
NOTICE: Steps 10 to 17 are temporary reassembly procedures for adjustment purposes. PROCEDURE
1. INSTALL STRAIGHT PIN (a) Using a plastic-faced hammer, install the 4 straight pins to the rear differential carrier sub-assembly.
*a 8.0 to 9.0 mm (0.3
© 2023-2026 Copyright www.tocamry.com
