Toyota Camry (XV70): Brake Pedal
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 BRAKE LINE
*2 BRAKE MASTER CYLINDER SUB-ASSEMBLY
Tightening torque for "Major areas involving basic vehicle performance such as moving/tur
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during br
Adjustment
ADJUSTMENT PROCEDURE 1. INSPECT AND ADJUST BRAKE PEDAL HEIGHT
(a) Remove the front door scuff plate LH. Click here
(b) Remove the cowl side trim sub-assembly LH.
Click here (c) Remove the No
SEE MORE:
Brake Hold Standby Indicator Light Circuit
DESCRIPTION The brake hold standby indicator light turns on if brake hold control is possible when the following conditions required for operation standby are met and the brake hold switch (electric parking brake switch assembly) is pressed while the ignition switch on.
Conditions required for
Multi-axis Acceleration Sensor Module "A" Circuit Voltage Out of Range (C05201C)
DESCRIPTION The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.
When the skid control ECU (brake actuator assembly) detects an abnormal acceleration sensor (airbag sensor assembly) signal, or the control value calculated using the accelerat
© 2023-2026 Copyright www.tocamry.com
