Toyota Camry (XV70): Inspection
INSPECTION
PROCEDURE
1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR
CAUTION:
- Do not put your hands into the water that has been heated for the inspection.
- Touching the heated water could result in burns.
| (a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
NOTICE: If checking the engine coolant temperature sensor in water, be careful not to allow water to contact the terminals. After checking, wipe the water off the engine coolant temperature sensor. If the result is not as specified, replace the engine coolant temperature sensor. |
|
READ NEXT:
Installation
INSTALLATION PROCEDURE 1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR
HINT: Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
Click here
(a) Apply a li
Components
COMPONENTS ILLUSTRATION
*1 FRONT FLOOR COVER LH
*2 FRONT FLOOR COVER RH
N*m (kgf*cm, ft.*lbf): Specified torque
- - ILLUSTRATION
*1 BODY MOUN
SEE MORE:
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the GTS to the DLC3.
(b) Turn the ignition switch to ON. (c) Turn the intuitive parking assist system on.
(d) Turn the GTS on. (e) Enter the following menus: Body Electrical / Clearance Warning / Trouble Codes.
(f) Check for DTCs. Body Electrical > Cl
Installation
INSTALLATION PROCEDURE 1. INSTALL THROTTLE BODY GASKET
(a) Install a new throttle body gasket to the intake air surge tank assembly with the protrusion of the throttle body gasket oriented as shown in the illustration.
*a Protrusion
2. INSTALL THROTT
© 2023-2026 Copyright www.tocamry.com
