Toyota Camry (XV70): Components
COMPONENTS
ILLUSTRATION
|
*1 | FRONT FLOOR COVER LH |
*2 | FRONT FLOOR COVER RH |
.png) |
N*m (kgf*cm, ft.*lbf): Specified torque |
- | - |
ILLUSTRATION
|
*1 | BODY MOUNTING PLATE |
*2 | NO. 1 ENGINE UNDER COVER |
|
*3 | REAR ENGINE UNDER COVER RH |
*4 | FRONT WHEEL OPENING EXTENSION PAD LH |
|
*5 | FRONT WHEEL OPENING EXTENSION PAD RH |
- | - |
|
|
N*m (kgf*cm, ft.*lbf): Specified torque |
- | - |
ILLUSTRATION
|
*1 | FRONT EXHAUST PIPE ASSEMBLY |
*2 | NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Lower Side) |
|
*3 | HEATED OXYGEN SENSOR (for Bank 2) |
*4 | HEATED OXYGEN SENSOR (for Bank 1) |
|
*5 | GASKET |
- | - |
|
|
N*m (kgf*cm, ft.*lbf): Specified torque |
* | For use with SST |
|
● | Non-reusable part |
- | - |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during he
Inspection
INSPECTION PROCEDURE 1. INSPECT HEATED OXYGEN SENSOR (for Bank 1)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Con
Installation
INSTALLATION PROCEDURE 1. INSTALL HEATED OXYGEN SENSOR (for Bank 2)
HINT: Perform "Inspection After Repair" after replacing the heated oxygen sensor.
Click here
(a) Using SST, install
SEE MORE:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table.
Check each symptom by checkin
Disposal
DISPOSAL PROCEDURE 1. DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY
CAUTION:
Always use a cloth to prevent shards of metal flying about due to the release of pressurized gas.
Always wear safety glasses.
HINT: The gas is colorless, odorless and non-poisonous.
(a) Place the front shoc
© 2023-2026 Copyright www.tocamry.com
