Toyota Camry (XV70): Installation
INSTALLATION
PROCEDURE
1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR
HINT:
Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
Click here .gif)
(a) Apply a light coat of engine coolant to the O-ring of the engine coolant temperature sensor.
NOTICE:
If reusing the engine coolant temperature sensor, be sure to inspect the O-ring.
(b) Install the engine coolant temperature sensor to the water outlet with the clip.
NOTICE:
- If the engine coolant temperature sensor has been struck or dropped, replace it.
- Make sure that the O-ring is not cracked or moved out of place when installing the engine coolant temperature sensor.
(c) Connect the engine coolant temperature sensor connector.
2. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
Click here
3. ADD ENGINE COOLANT
Click here
4. INSPECT FOR COOLANT LEAK
Click here
5. PERFORM INITIALIZATION
(a) Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 FRONT FLOOR COVER LH
*2 FRONT FLOOR COVER RH
N*m (kgf*cm, ft.*lbf): Specified torque
- - ILLUSTRATION
*1 BODY MOUN
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during he
SEE MORE:
Replacement
REPLACEMENT CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transfer case oil seal RH removal/installation are shown below. Necessary Procedures After Parts R
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected
