Toyota Camry (XV70): Brake Booster
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
- - ILLUSTRATION
*1 FRONT CENTER UPPER SUSPENSION BRACE SUB-ASSEMBLY
- -
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT BRAKE BOOSTER ASSEMBLY (a) Airtightness check
(1) Start the engine and stop it after 1 or 2 minutes. Slowly depress the brake pedal several times.
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during br
SEE MORE:
Terminals Of Ecu
TERMINALS OF ECU CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY)
(a) Disconnect the q1 sliding roof ECU (sliding roof drive gear assembly) connector.
(b) Measure the resistance and voltage according to the value(s) in the table below.
HINT: Measure the values on the wire harness
Installation
INSTALLATION PROCEDURE 1. INSTALL REAR ROOM LIGHT BULB (for Bulb Type)
(a) Install the rear room light bulb to the room light switch base. 2. INSTALL ROOM LIGHT ASSEMBLY (for Bulb Type)
(a) Align the switch parts as shown in the illustration and engage the 4 claws to install the room light swi
© 2023-2026 Copyright www.tocamry.com
