Toyota Camry (XV70): Installation
Toyota Camry Repair Manual XV70 (2018-2024) / Brake / Brake System (other) / Brake Booster / Installation
INSTALLATION
PROCEDURE
1. INSTALL BRAKE BOOSTER GASKET
(a) Install a new brake booster gasket to the brake booster assembly.
2. INSTALL BRAKE BOOSTER ASSEMBLY
(a) Temporarily install the brake booster assembly to the vehicle body.
NOTICE:
Do not apply excessive force to the brake lines.
(b) Temporarily install the lock nut and brake master cylinder push rod clevis to the brake booster assembly.
NOTICE:
Fully tighten the lock nut when adjusting the brake pedal height.
(c) Install the 4 nuts to secure the brake booster assembly.
Torque:
12.8 N
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY
- - ILLUSTRATION
*A except 2-Pot Caliper
*B for 2-Pot Caliper
*C w/o
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT BRAKE FLUID LEVEL IN RESERVOIR
(a) Check the fluid level. If the brake fluid level is lower than the MIN line, inspect for brake fluid leaks and brak
SEE MORE:
Parts Location
PARTS LOCATION ILLUSTRATION
*A w/ Side Turn Signal Light
- -
*1 HEADLIGHT ASSEMBLY RH
- TURN SIGNAL LIGHT *2
HEADLIGHT ASSEMBLY LH - TURN SIGNAL LIGHT
*3 SIDE TURN SIGNAL LIGHT ASSEMBLY RH
*4 SIDE TURN SIGNAL LIGHT ASSEMBLY LH
*5 REAR COMBI
Hood
Release the lock from the inside of the vehicle to open the hood.
1. Pull the hood lock release lever.
The hood will pop up slightly.
2. Pull up the auxiliary catch lever
and lift the hood.
3. Hold the hood open by inserting
the support rod into the slot.
■Open hood warning buzzer
© 2023-2026 Copyright www.tocamry.com
