Toyota Camry owners & service manuals

Toyota Camry (XV70): Installation

Toyota Camry Repair Manual XV70 (2018-2024) / Drivetrain / Ua80e (automatic Transmission / Transaxle) / Oil Cooler / Installation

INSTALLATION

PROCEDURE

1. INSTALL TRANSMISSION OIL COOLER

(a) Temporarily install the transmission oil cooler to the automatic transaxle case sub-assembly with the bolt (A).

(b) Install the bolt (B).

Torque:

13.5 N

    READ NEXT:

     Oil Pump

     Components

    COMPONENTS ILLUSTRATION *1 CLUTCH DRUM OIL SEAL RING *2 FRONT OIL PUMP BODY *3 FRONT OIL PUMP DRIVE GEAR *4 FRONT OIL PUMP DRIVEN GEAR *5 OIL STRAINER A

     Disassembly

    DISASSEMBLY PROCEDURE 1. REMOVE CLUTCH DRUM OIL SEAL RING (a) Remove the 4 clutch drum oil seal rings from the stator shaft assembly. 2. REMOVE OIL STRAINER ASSEMBLY (

    SEE MORE:

     Removal

    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during roof antenna assembly removal/installation are shown below. Necessary Procedure After Parts Removed/I

     Steering Pad Switch Circuit

    DESCRIPTION This circuit sends an operation signal from the steering pad switch assembly to the radio and display receiver assembly. If there is an open in the circuit, the audio system cannot be operated using the steering pad switch assembly. If there is a short in the circuit, the same condit

    © 2023-2026 Copyright www.tocamry.com