Toyota Camry (XV70): Slip Indicator Light Remains ON
DESCRIPTION
This procedure is for troubleshooting when the slip indicator light remains on but no DTCs are output.
The skid control ECU (brake actuator assembly) controls the slip indicator light in the combination meter assembly via CAN communication.
The slip indicator light blinks during VSC and/or TRAC operation.
If a malfunction is detected, the slip indicator light comes on to warn the driver.
CAUTION / NOTICE / HINT
NOTICE:
After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and system information memorization.
Click here .gif)
PROCEDURE
| 1. |
CHECK VEHICLE CONTROL HISTORY (RoB) (VEHICLE STABILITY CONTROL SYSTEM) |
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Enter the following menus: Chassis / Brake / Utility / Vehicle Control History (RoB).
(d) Using the Techstream, check for Vehicle Control History (RoB).
Click here
|
Tester Display |
|---|
| Vehicle Control History (RoB) |
HINT:
If vehicle control history is stored when the vehicle stability control system is suspended, the slip indicator light illuminates.
|
Result | Proceed to |
|---|---|
|
There is no vehicle control history (RoB) for when the vehicle stability control system was suspended. |
A |
| There is vehicle control history (RoB) for when the vehicle stability control system was suspended. |
B |
| B |
.gif) | PERFORM TROUBLESHOOTING AND REPAIR REGARDING VEHICLE CONTROL HISTORY (RoB) NOTICE: After performing troubleshooting and repair regarding vehicle control history (RoB), clear the vehicle control history (RoB). |
|
.gif)
| 2. |
INSPECT COMBINATION METER ASSEMBLY |
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Enter the following menus: Body Electrical / Combination Meter / Active Test.
(d) Perform the Active Test of the combination meter assembly using the Techstream.
Click here
|
Tester Display |
|---|
| Slip Warning |
(e) Check the combination meter assembly.
OK:
The slip indicator light turns on or off in accordance with Techstream operation.
| OK | | REPLACE BRAKE ACTUATOR ASSEMBLY |
| NG | | INSPECT METER / GAUGE SYSTEM |
READ NEXT:
Slip Indicator Light does not Come ON
DESCRIPTION The skid control ECU (brake actuator assembly) controls the slip indicator light in the combination meter assembly via CAN communication. CAUTION / NOTICE / HINT
NOTICE: After replacing
FL Speed Sensor Wrong Installation (X0451)
DESCRIPTION
Code Tester Display
Measurement Item Trouble Area
X0451 FL Speed Sensor Wrong Installation
History of front speed sensor LH being installed incorrectly
FR Speed Sensor Wrong Installation (X0452)
DESCRIPTION
Code Tester Display
Measurement Item Trouble Area
X0452 FR Speed Sensor Wrong Installation
History of front speed sensor RH being installed incorrectly
SEE MORE:
Parts Location
PARTS LOCATION ILLUSTRATION
*1 OUTER MIRROR SWITCH ASSEMBLY
*2 OUTER REAR VIEW MIRROR ASSEMBLY LH
*3 OUTER REAR VIEW MIRROR ASSEMBLY RH
*4 OUTER MIRROR LH
*5 OUTER MIRROR RH
*6 MIRROR SELECT AND SURFACE ADJUST SWITCH
*7 ENGIN
Brake Switch "A" Circuit Short to Battery (P057112)
DESCRIPTION The skid control ECU (brake actuator assembly) receives stop light switch assembly signals and uses them to determine whether or not the brakes are applied.
DTCs may be stored if either of the following occurs:
Stop light switch assembly stuck on malfunction.
The accelerator a
