Toyota Camry (XV70): Installation
INSTALLATION
PROCEDURE
1. INSTALL MASS AIR FLOW METER SUB-ASSEMBLY
HINT:
Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.
Click here .gif)
(a) Install the mass air flow meter sub-assembly to the air cleaner cap sub-assembly with the 2 screws.
NOTICE:
- If the mass air flow meter sub-assembly has been struck or dropped, replace it.
- If reusing the mass air flow meter sub-assembly, be sure to inspect the O-ring.
- Make sure that the O-ring is not cracked or moved out of place when installing the mass air flow meter sub-assembly.
(b) Connect the mass air flow meter sub-assembly connector.
2. PERFORM INITIALIZATION
(a) Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.
Click here
READ NEXT:
Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE
1. INSPECT NO. 1 ELECTRONIC FUEL INJECTION MAIN RELAY (EFI-MAIN NO. 1)
(a) Measure the resistance according to the value(s) in the table be
Precaution
PRECAUTION INITIALIZATION
NOTICE:
Before replacing the ECM, refer to Registration.
Click here
Perform Registration (VIN registration) after replacing the ECM.
Click here
Perform L
SEE MORE:
Washer Fluid Level Warning Switch Circuit
DESCRIPTION When the washer fluid level is lower than a certain level, a warning message is displayed on the combination meter assembly. WIRING DIAGRAM
PROCEDURE
1.
READ VALUE USING TECHSTREAM (a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch ON. (c) Turn the Te
Engine Switch Illumination Circuit
DESCRIPTION The illuminated entry system controls the engine switch illumination. WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE: Before replacing the certification ECU (smart key ECU assembly), refer to Registration.*
Click here
*: w/ Smart Key System
PROCEDURE
1. PERFORM ACTIV
© 2023-2026 Copyright www.tocamry.com
